Ultimat Futura accessory pack
A complete accessory pack for those who need to accurately position extra-large boards or wish to easily undertake more creative cutting.
Product information >
75cm extension mat guide kit
Perfect for square, accurate position when cutting large mount boards, multiple openings, title boxes or just very wide margins.
Product information >
Multi-angle cutting gauges
Three different angled plates which clip instantly into the margin guide, giving predictable and accurate positioning for the mountboard to be marked or cut on an angle. The chosen angles were researched to provide creative scope to a framer with no need for fiddly adjustments. For special creative cutting, more than one angle plate can be located in the margin guide at one time.
Product information >
60cm support arms
Extension arms that clip on increasing the width of the base to 100cm (39”), to hold large boards flat and square by preventing sag. Use on the left with the margin guide, or on the right with the squaring arm.
Product information >
Reverse bevel stop
Add this to your cutter to produce a reversed bevel mat without over or under cuts. These mats can then accept ‘slips’ or ‘fillets’ producing a clean tight joint between the slip and the mat.
Product information >
Tech-D.012 blades
A pack of 100, double ground, 0.3mm (0.012”) thick blades, made from a high grade steel, giving increased durability and reduced blade tip wear/breakage. This blade is used for bevel and vertical cutting.
Product information >
Tech-D.015 blades
A pack of 100, double ground, 0.4mm (0.015”) thick blades made from a high grade steel, giving increased durability and reduced blade tip wear/breakage. Used for bevel cutting soft, thicker boards.
Product information >
Tech-S.012 blades
A pack of 100, single ground, chisel edge 0.3mm (0.012”) thick blades, made from a high grade steel, giving increased durability and reduced blade tip wear/breakage. Used for bevel cutting harder boards like conservation and white core boards up to 3mm (1/8″).
Product information >
Tech-S.015 blades
A pack of 100, single ground, chisel edge 0.4mm (0.015”) thick blades, made from a high grade steel, giving increased durability and reduced blade tip wear/breakage. Used for bevel cutting harder boards like conservation and white core boards thicker than 3mm (1/8″).
Product information >
Keencut-080 superior quality blades
A pack of 100, double ground edge 0.43mm (0.017”) thick blades, made from a high grade steel, giving increased durability and reduced blade tip wear/breakage. The blades can be used for vertical cutting.
Product information >
Futura squaring arm
Easy clip on and off arm to help cut material precisely square to a pre-determined size whilst providing additional material support.
Product information >
