Keencut

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
October 7, 2022 at 2:50 pm in reply to: Start of Cut Finger #50846

PhilippeA6
Participant

Thanks a lot. Now I understand everything I hope. I missed the teeth on the underside. I was just pushing it against the board. I think you should add that in your manual.

September 16, 2022 at 3:08 pm in reply to: How many cuts with a blade ? #50680

PhilippeA6
Participant

Thanks for your answer. So at the beginning I am on the safe side if I use each side of a Tech D 012 blade to open a window 30×40 cm in a 40×50 cm board ?
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)