Start of Cut Finger - Keencut

This topic has 3 replies, 2 voices, and was last updated 2 years, 10 months ago by Technical.

Viewing 3 reply threads

Author

Posts
- October 7, 2022 at 1:05 pm #50844
  
  PhilippeA6
  Participant
  
  Let me apologize if my english is far from perfect, I am french. I have a question about the Start of Cut Finger, sometimes it’s moving a little bit back when I insert the blade and then I get a little beginning overcut.
  
  When I make wrong and how to avoid that problem ? Just a question of strengh ? Thanks for your help.
- October 7, 2022 at 2:26 pm #50845
  
  Technical
  Participant
  
  Hi Philippe,
  
  Firstly, your English is actually very good, and an awful lot better than my French! The start of cut finger (the aluminium block our push down) has two purposes. It both positions the blade in the correct position and by pressing down on it firmly holds the cutting head in position preventing it from moving away from you as the blade enters. So as you say it is a question of strength when pushing the finger down, you will notice there are teeth on the underside of it to help.
  
  I hope that helps, please let us know if we can be any further assistance.
- October 7, 2022 at 2:50 pm #50846
  
  PhilippeA6
  Participant
  
  Thanks a lot. Now I understand everything I hope. I missed the teeth on the underside. I was just pushing it against the board. I think you should add that in your manual.
- October 7, 2022 at 3:00 pm #50847
  
  Technical
  Participant
  
  Yes, good point, I have to say I thought it did, we will get it changed. Thanks
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.