NOTE: Orientation is very important, damage can result if fitted incorrectly.
Please observe: the bottom end of the lever has a plain ‘flat’ face on one side and a ‘recess’ machined in its opposite face
Loosen the lever fixing screw using the 5mm Allen (hex) key, if there is a lever already in place carefully remove it. The small flat bladed screwdriver can help here to separate the mating part from the lever.
Evolution3 BenchTop and SmartFold
Fit new lever in place ensuring the ‘recessed’ face of the lever is facing towards the middle of the machine.
Evolution E2 only
Fit new lever in place ensuring the ‘flat’ face of the lever is facing towards the middle of the machine.
Once the mating part in the machine can be seen to mate with the ‘recess’ in the lever fully tighten the fixing screw using the 5mm Allen (hex) key.