To do this you will need the SteelTrak left hand support arm assembly >

Tools required:

• Allen (hex) key 4mm

What to do

• If replacing, remove the existing support arm by undoing the four screws using a 4mm Allen (hex) key
• To fit the new support arm hold it in place with the right-hand end resting in place along the edge of the main body of the machine. Push the two long fixing screws through the two holes in the leg from the back, use the 4mm Allen (hex) key and screw them into the special fixing grooves in the back of the support arm, do not tighten them at this stage.