Generic filters
Exact matches only
Search in title
Search in content
Search in excerpt

How to replace the sliding cutting head for Flexo Plate Cutter

To do this you will need the Flexo Plate Cutter complete head assembly >

Tools required:

  • Posi screwdriver
  • Worn scouring pad
  • Cleaning cloth
  • Petroleum jelly (Vaseline)

 

What to do

  • Remove both blade cartridges.
  • Raise the cutter bar fully using the black handle.
  • Rotate the cutter bar to reveal two posi-screws fixing the small aluminium block to the cutter bar, supporting the cutter bar remove both screws.
  • Lower the cutter bar back onto the base, hold the cutter bar to the base plate and lift the black handle to free the block.
  • Lift the black handle just enough to clear the top of the cutter head, slide off both the end stop and the cutting head.
  • Use the opportunity to clean and lubricate the two guide bars. Using a worn scouring pad with a small amount of petroleum jelly rub the two guide bars to remove any debris and stains, wipe with a clean cloth and finally apply a very thin smear of petroleum jelly
  • Slide the new head onto the end of the cutter bar, the third track roller will need a firm push with the palm of your hand, hand protection is wise in case you slip.
  • Replace the end stop and refix the two posi-screws.

Did you find this helpful?

Yes / No